4 x Enrock 6x9" Marine Speakers, 4 Channel Amp, Controller, Amp Installation Kit
Enrock Marine 4-Channel Marine/Powersports Amplifier 45 Watts RMS @ 4 ohms, for use in Car, Boat, RV, Patio
Enrock's EEA720.4 4-channel amplifier was designed compact yet rugged. The outdoors can be a tough spot for audio gear so Enrock considered the salt, spray and sunlight when designing this Class D amplifier. With 45 watts RMS per channel this amplifier will drive your speakers no matter the application you are using it for. It’s compact enough for a bike and powerful enough for a car. You’ll have no trouble hearing your tunes over the wind and waves with this powerful amplifier.
Weather Resistant for Marine Application
Durable and Powerful for Automotive Use
Compact and rugged for Off-Road Installation
This compact amplifier will fit into a storage compartment on a boat, motorcycle, ATV, or car with optimal performance, despite its size. Should you decide to add a pair of subwoofers you can bridge this amp to a 2-channel mode and send 120 watts to each subwoofer, or switch to 3-channel mode to get a pair of speakers and a subwoofer. With high-pass and low-pass filters, plus bass boost, you can customize your sound output just the way you take your tunes.
EE1720 GENERAL FEATURES:
- 4-channel marine/powersports/ car amplifier
- 45 watts RMS x 4 at 4 ohms (60 watts RMS x 4 at 2 ohms)
- 120 watts x 2 bridged at 4 ohms
- Class D amp technology
- 720 Watts Peak Power
- variable high- and low-pass filters
- Sealed Chassis for use in harsh environments
- Ultra-efficient full range class D operation
- Built-in Crossover- maximum flexibility
- 2 or 4 channel input
- Signal to noise radio 97db
- High pass filter 120Hz/80Hz
- Input range: 200mV-10V
- Frequency Response: 20Hz to 20KHz
UPC Code 728120454069
Enrock Marine EM692B Black Dual 6X9" Inch Weather Resistant Full Range Speakers 250 Watts Peak (Pair) (x2)
The high-quality 6-1/2" speakers feature one-piece baskets that keep water out and polypropylene cones that will withstand heat and sun. These speakers are constructed with thick, heavy-duty plastic, assuring you safety and durability in the marine environment. The hardware is equipped with rust-resistant material, and speaker surrounds are corrosion-resistant. Designed for years of trouble-free operation.
SPEAKERS:
Specs:
Speaker Type: Full Range
Configuration: 2-Way
Peak Power Handling: 250Watts
RMS Power: 30Watts
Impedance: 4 Ohm
Sensitivity: 85dB
Frequency Response: 88Hz20kHz
Tweeter: 30mm Mylar
.5 inch Pewter Dual Cone Design
30 Watt Marine Speaker System
Rust Proof Basket ? Water Resistant?
High Temperature and UV Resistant
ABS Polymer Construction
Injection-Molded Polypropylene Cone
Features
Speaker Type Full Range
Configuration 2-Way
Peak Power Handling 250Watts
RMS Power 30Watts
Impedance 4 Ohm
Sensitivity 85dB
Frequency Response 88Hz ?20kHz
Tweeter 30mm Mylar
In the box:
2 speakers
Owners Manual
Screws
UPC Code 728120498742
MB Quart N1-WBT Waterproof Wired Bluetooth Preamp Controller
Stream tunes from your Bluetooth-enabled device to your vehicle's or boat's amplifier with this MB Quart N1-WBT preamp controller, which offers a water-resistant design for durability. The controller pairs via Bluetooth from up to 32' away.
When connected to a receiver the controller and remote will not work simultaneously. Bluetooth function will only work via the amplifier to stream music from your phone.
- Marine certified.
- Controls the main features of a receiver: power, mode, volume, tune/track.
- Wired connection via a 3.5mm cable.
- IPX6 Waterproof, UV and salt resistant.
- Compact design for easy installation.
- Simple audio outputs to connect to an amplifier.
- Bluetooth Connectivity allows your phone or other Bluetooth enabled device to be quickly paired to the controller without a complicated pairing process.
- Bluetooth Range: Approximately 32' (10m)
- 2volt Preamp Output
- Controller Diameter: 2" (4.8cm)
UPC Code 806576223474
PYLE PLMRAKT8 Marine Grade 8 Gauge Amplifier Installation Kit
Get all the wires you need to hook up a new marine audio system with this Pyle Hydra amplifier installation kit. These wires have high resistance to moisture, so they’re a great fit on your boat or in outdoor settings. Included wires: 20 ft. 8-gauge red power wire, 4 ft. 8 gauge black ground wire, 20 ft. 18-gauge blue remote turn-on, 20 f. 12 gauge stereo speaker wire, 20 ft. stereo RCA cable, and 6 ft. black split loom cable conduit. Also includes an AGU type 60A gold-plated fuse, water resistant in-line fuse holder, two 8G ring terminals, two 8G spade terminals, five 14-16G spade terminals, 3 butt connectors, 20 cable ties, and one black grommet.
UPC Code 068888882415
1 Year Manufacturer Warranty