JBL A1000 1000W Subwoofer Amplifier Bundle with 2x 12” Subwoofers & Wiring Kit
The JBL Club A1000 mono subwoofer amplifier delivers 1000-Watts RMS using a Class D amplifier design to ensure high output and minimum current draw. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your car's factory radio. You can use the low-pass filter and variable bass boost to maximize the performance of your subwoofer and enclosure, while a phase switch ensures that the bass will blend well with your full-range speakers.
General Features:
- 600 watts RMS x 1 at 4 ohms (1000 watts RMS x 1 at 2 ohms)
- Class D amp technology
- frequency response: 10-320 Hz
- variable low-pass filter (32-320 Hz, 12 dB/octave)
- variable bass boost (0-12dB at 45Hz)
- phase switch (0, 180 degrees)
- wired remote level control included
- preamp inputs and outputs
- speaker-level inputs (speaker wire-to-RCA adapters included)
- 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- fuse rating: 35A x 3
- WxHxD=12-5/8” x 2-1/16" x7-1/8”
UPC Code 050036369183
The JBL Stadium 122SSI 12" component subwoofer is the high-performance bass machine you need to take your audio system to the next level. This subwoofer can pump out 1350 watts of peak power and 450 watts of RMS power for an impressive sonic output. A switch which lets you vary the sub's impedance from 2 ohms to 4 ohms to optimize its effectiveness.
General Features:
- 450 watts RMS (1350 watts peak)
- 12" high-performance car subwoofer
- Glass fiber/paper pulp composite cone
- Nitrile rubber surround
- Stamped steel vented basket
- SSI (Selectable Smart Impedance): 2 or 4 ohms switchable
- Grille not included
UPC Code 050036381185
The Enrock 8-Gauge Amplifier Installation Kit makes installing your brand new sound system in your car or truck much easier. It includes all of the cables, wires, tubing, ties, grommets and ring terminals that you will need in order to get your new sound system up and running.
The car amp install kit works with a wide range of sound systems and car types and it makes the installation process much simpler by conveniently adding all your supplies to one single kit.
Kit Includes:
- 20 ft. 8 GA Red Power Cable.
- Competition High Quality Fuse Holder.
- 1/4" Ring Terminal.
- 3 ft. 8 GA Black Ground Cable #10 Ring Terminal.
- 16 ft. 18 GA Blue Turn-On Wire.
- 20 ft. High Performance RCA (TRCA) Interconnect (3) Rubber Grommets.
- 30 ft. Speaker Wire 5/16" Ring Terminal.
- 6 ft. Split Loom Tubing (20) 4" Wire Ties.
UPC Code 728120451105