Kicker 5.25" Marine Speakers,N1WBT Bluetooth Controller,Amplfier and Install Kit
Stream tunes from your Bluetooth-enabled device to your vehicle's or boat's amplifier with this MB Quart N1-WBT preamp controller, which offers a water-resistant design for durability. The controller pairs via Bluetooth from up to 32' away.
- Marine certified.
- Controls the main features of a receiver: power, mode, volume, tune/track.
- Wired connection via a 3.5mm cable.
- IPX6 Waterproof, UV and salt resistant.
- Compact design for easy installation.
- Simple audio outputs to connect to an amplifier.
- Bluetooth Connectivity allows your phone or other Bluetooth enabled device to be quickly paired
- to the controller without a complicated pairing process.
- Bluetooth Range: Approximately 32' (10m)
- 2volt Preamp Output
- Controller Diameter: 2" (4.8cm)
UPC Code 806576223474
PXA-Series Power Amplifiers are specifically designed for motorized vehicles with small battery/charging systems, and in an incredibly small footprint that can be installed in motorcycle saddle bags or fairings, glove compartments and other previously unusable spaces.
- Power Handling:
- 25 Watts RMS x 2 @ 4 Ohm
- 50 Watts RMS x 2 @ 2 Ohm
- Total 200 Watts RMS x 2 @ 1 Ohm
- Input sensitivity:
- Low level: 125mV - 5V
- High level: 250mV - 10V
- Features:
- No-rust, stainless-steel mounting hardware and a single Molex plug
- Two auto turn-on modes (DC offset or 12-volt trigger)
- Weather-resistant with a conformal-coated circuit board
- RCA & High-Level Inputs Connections
- Signal to Noise Ratio: 95 dB
- Active Crossover: 12dB/octave, selectable 60, 80 or 120Hz hi-pass or off
- Amplifier Class - Direct
- Voltage Range - 10V-16V
- Terminals - Pigtail
- Turn on Modes - 12V / DC Offset
- Fuse Rating: 15A x 1 (external)
- Frequency Response - 10Hz-20kHz
- SN Ratio - 95dB
- Low Level Input Sensitivity - 125mV-5V
- High Level Input Sensitivity - 250mV-10V
- Electronic Crossover - Selectable Hi-Pass or Off, 60-/80-/120Hz @ 12dB/Octave
- Fuse Rating - 15A
- Accessories Included - (1) fuse holder, (1) wire harness, (4) screws, (2) terminals
- Dimensions - 7" L x 1-9/16" H x 3-7/16"
UPC Code 713034073734
This motorcycle amp power kits start with the best quality copper wire available for maximum current delivery and strict adherence to American Wire Gauge standards. Add to that our use of pure oxygen free copper flux-tinned conductors and braided sleeving that deliver excellent corrosion resistance and installation reliability and you have the foundation for an exceptional audio power product. These motorcycle power amp kits are topped off with a unique waterproof mini-ANL fuse block design with machined brass inserts that affords convenient access along with installation security.
*The amp power kits come complete with all the cabling, speaker wires, terminals, disconnects, and fuse blocks needed to perform a quality installation, except for RCA interconnects. Since we offer various levels of high performance RCA interconnects for aftermarket radios and high-level input for OEM upgrades, we leave it up to the consumer/dealer to make the RCA choice.
- 6-ft - 10-gauge power cable.
- 6-ft - 10-gauge ground cable.
- 3-ft - 18-gauge turn-on lead wire.
- 2x 4ft speaker wires.
- In-line waterproof Mini-ANL fuse holder and 30-amp fuse.
UPC Code 033991048645
New Pair Kicker 10 PS5250 4-Ohm 5-¼" 2-way Marine Harley Davidson Motorcycle Coaxial Speakers System
Kicker PS52504 motorcycle speakers were designed to replace some Harley-Davidson and Victory factory speakers. But when tunes are imperative for a joyride those make a superb replacement for other motorcycle, ATVs and marine applications. The weather-resistant design used to create these speakers only means one thing…they’ll last a long time wherever you place them.
The speakers’ motor structures designed around a light yet powerful, neodymium magnet, so the PS52504 speakers weigh only 12 ounces per speaker, amazingly light for speakers that pack this kind of punch. It creates the perfect pair for mounting on motorcycles, where keeping a low center of gravity hits handling and performance.
Kicker placed the titanium dome tweeter above the woofer, enabling the polypropylene cone to move freely for more bass. Turn up your tunes since these speakers are designed to withstand the heat caused by loud sounds for lengthy periods of time
What’s in the box:
UPC Code 713034055730
![]() |