Bluetooth Controller, 4x 6.5" 180 Watts Peak Marine Speakers, Amp W/Wiring Kit
Metra IBBTR19 Marine 3-Zone Bluetooth Controller
This easy-to-install controller with Bluetooth wireless technology puts audio controls at your fingertips. It allows users to control the volume independently for three zones or simultaneously on the primary setting. An LED backlight on the remote indicates which zone is active. The controller is equipped with built-in connectivity with Bluetooth technology and auxiliary input. A high-quality internal digital signal processor produces lossless audio output to your sound system. The controller is rated IPX7, making it ideal for marine and powersports applications.
Features
- Control volume +/-, track FWD/PREV, PLAY/PAUSE, and auxiliary input
- Control the volume of 3 zones independently
- LED backlit controller
- Equipped with Bluetooth® wireless technology
- Supports APTX-HD, APTX, APTX-X Low Latency, SBC, and ACC audio formats
- 24-bit lossless audio processor
- Rated IPX7 for powersports & marine applications
- Switch between Bluetooth® wireless technology & auxiliary inputs
- Amplifier remote turn-on output
UPC Code 086429430727
JBL Marine Stage 6 6.5" OEM Replacement 180 Watts Max Power 2-Way Multi-Element Gray Marine Speakers (Pair, Bulk Packaging) (x2)
JBL Stage Marine Speakers are ready to take on your next outdoor adventure. These fully marinized speakers not only deliver JBL sound, but they bring the sound to life. Engineered to withstand sun, salt, sea spray and wash downs, they feature sealed motor structure, UV resistant one-piece cast-polymer baskets and rubber surrounds. The polypropyelene cone and balanced dome tweeter provide great bass, smooth highs and lots of output to ensure every note can be heard loud and clear.
General Features:
- 6-1/2" (160mm) Marine Two-way Speaker with 1/2" (13mm) tweeter
- Power Handling: 60W rms, 180W peak
- Sensitivity (@ 2.83V): 90dB
- Frequency Response: 60Hz – 20kHz
- Nominal Impedance: 4 ohms
- IPx5 Rated
- Grille Mounted Tweeters
- Polymer Basket
- Individually Voiced
- Harman Standard Reliability Tested
- Bulk Packaging
UPC Code
JBL Marine A754 75 Watts RMS x 4 @ 4 Ohms 4-Channel Class H Boat Amplifier
The JBL Marine A754 4-channel amplifier delivers a powerful 75-Watts RMS to each of the front and rear speakers in your boat. You can also bridge the amp to 2-channel mode to drive a couple subs with 200 watts RMS or 3-channel mode to drive both a pair of full range speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your Marine’s factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics.
General Features:
- 4 channel Marine amplifier
- 75 watts RMS x 4 at 4 ohms (100 watts RMS x 4 at 2 ohms)
- 200 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
- Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- Preamp and speaker-level inputs
- Preamp outputs
- Fuse rating: 30A x 2
- 8-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=320mm x 51.3mm x 180mm WxHxD=12-5/8” x 2-1/16” x 7-1/8”
UPC Code 050036396943
Metra ML-AK8-10 8 Gauge Amplifier Wiring Marine Kit - 10ft. w/ Circuit Breaker
Power your marine amplifier with a wiring kit that can withstand the harsh environment and still deliver full sound performance. Fully tinned wiring ensures that these amp kits won’t corrode or oxidize and turn green after a season on the water. Oxygen-free copper provides a reliable connection with maximum conductivity. By using 100% virgin copper the tin won’t flake off, something commonly seen when using recycled copper materials. While it is also common to tin just the tips of the wire for cost savings, this practice does not actually provide any benefits. Metra’s amp kits use fully tinned copper wire from top to bottom that can withstand a harsh marine environment and salty air. The ignition-protected 50-amp circuit breaker is IP67 rated with stainless steel connection points for corrosion resistance
Amplifier Wiring Kit:
- Marine compliant amplifier wiring kit
- Fully tinned 100% virgin copper wire
- BC5W2 marine compliant jacket
- 50-amp marine circuit breaker is rated IP67 with stainless steel connection points for corrosion resistance
- Easy to solder tinned wiring
- Connectors, ring terminals, and wire ties included
What’s in the box:
- (1) 8-gauge tinned oxygen-free copper side-by-side red power and yellow ground wire (10ft.)
- (1) 18-gauge tinned oxygen-free copper blue remote turn-on wire (18ft.)
- (2) 8-gauge ring terminal with shrink tube and logo, pre-terminated on each end of the 2ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on 8ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on yellow wire
- (1) Ignition protected circuit breaker (50-amp)
UPC Code 086429416820
Enrock 20-Feet 16 Gauge Marine Grade Tinned Speaker Wire -Oxygen Free Copper (OFC) 16-AWG
A ground-breaking virgin-PVC, Hyper-Flex insulation and multi-strand construction allows you to bend, twist, and contort the cable in any way imaginable for an ultimate installation experience while delivering maximum current flow; remains ultra-flexible under hot or cold temperature extremes; transfers the cleanest audio signal possible by using tightly twisted, silver-tinned OFC copper conductors; zip line to easily remove outer insulation.
Speaker Wire:
- 20 Feet
- 16 Gauge
- Silver-tinned OFC (oxygen-free copper)
UPC Code 632016086404
1 Year Manufacturer Warranty
