Controller:
- Control volume +/-, track FWD/PREV, PLAY/PAUSE, and auxiliary input
- Control the volume of 3 zones independently
- LED backlit controller
- Equipped with Bluetooth wireless technology
- Supports APTX-HD, APTX, APTX-X Low Latency, SBC, and ACC audio formats
- 24-bit lossless audio processor
- Rated IPX7 for powersports & marine applications
- Switch between Bluetooth wireless technology & auxiliary inputs
- Amplifier remote turn-on output
- (3) 4V 2-channel RCA outputs
- Frequency range: 18Hz to 25KHz
- Bluetooth wireless technology range: 35ft
- Input voltage: 12V-24V
Speakers:
- Power Handling: 100 watts RMS, 300 watts peak power
- Sensitivity: 92dB at 2.83 volts
- Frequency Response: 40 - 25kHz
- Voice Coil Diameter: 1 in. (25.5mm)
- Impedance: 3 ohm impedance
- Plus One Woofer Cones
- Perimeter RGB Illumination
- One Piece Polymer Basket
- Mylar Tweeters
- Harman Standard Reliability Testing
DO NOT USE DRILLS ON THE SCREW SPEAKER TERMINALS EVER.
Loosen and Tighten BY HAND ONLY. Using a Drill snaps the solder connection on the back of the terminal and the X-over (coax) Circuit board.
Amplifier:
- 8 channel Marine amplifier
- 75 watts RMS x 8 at 4 ohms (125 watts RMS x 8 at 2 ohms)
- 250 watts RMS x 4 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
- Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- Preamp and speaker-level inputs
- Preamp outputs
- Fuse rating: 105A
- 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=360mm x 51.3mm x 180mm WxHxD=14-3/16” x 2-1/16” x7-1/8”
Amplifier Install Kit:
- Marine compliant amplifier wiring kit
- Fully tinned 100% virgin copper wire
- BC5W2 marine compliant jacket
- 50-amp marine circuit breaker is rated IP67 with stainless steel connection points for corrosion resistance
- Easy to solder tinned wiring
- Connectors, ring terminals, and wire ties included
What’s in the box:
- (1) 8-gauge tinned oxygen-free copper side-by-side red power and yellow ground wire (10ft.)
- (1) 18-gauge tinned oxygen-free copper blue remote turn-on wire (18ft.)
- (2) 8-gauge ring terminal with shrink tube and logo, pre-terminated on each end of the 2ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on 8ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on yellow wire
- (1) Ignition protected circuit breaker (50-amp)
1 Year Manufacturer Warranty
