JBL STAGE 102 10" 900 Watt Max Power Car Subwoofer, Full-Range Mono Amplifier
This JBL Stage subwoofer was engineered to deliver high-output, low-distortion bass with power handling capability of up to 900 watts peak power. This subwoofer features lightweight yet stiff polypropylene woofer cone with hi-roll rubber surround to provide high-efficiency and super durability to best interface with a variety of amplifiers.
General Features:
- Polypropylene Woofer Cone
- Hi-Roll Rubber Surround
- Individually Voiced
- Power Handling: 225Wrms, 900W peak
- Sensitivity (@2.83V): 89dB
- Frequency Response: 35Hz - 200Hz
- Voice Coil Diameter: 1.5 in. (38.8mm)
- Impedance: 4 ohms
UPC Code 050036381505
This compact JBL Stage Mono Subwoofer amplifier is equipped with all the important inputs and user controls including a bass EQ as well as LPF and HPF crossover controls for tailoring sound to suit the characteristics of different vehicles. The Stage amplifier is easily installed and amazingly reliable – and once it turns on, they’ll make a transducer sit up and sing. Black with deep grooves, silver silkscreen, anodized JBL badge top-center with orange end panels and bottom, this amplifier features a sleek, exterior design that will add a classy, visual flair while enhancing your vehicle's sound system!
General Features
- Mono Subwoofer Amplifier
- Value Engineered
- Compact footprint
- Full On-Board Protection
- Reliability
- Input Level Control
- Switchable bass EQ
- Cool industrial design
- Crossover mode switch
- Power Output: 600W Peak
- Power Output: 300Wx1 @ 2ohms
- Variable Low-Pass Filter: 32-320Hz
- Input Sensitivity: 0.2V-5V
- Frequency Response: 10-320Hz±3dB
UPC Code 050036357128
Power your marine amplifier with a wiring kit that can withstand the harsh environment and still deliver full sound performance. Fully tinned wiring ensures that these amp kits won’t corrode or oxidize and turn green after a season on the water. Oxygen-free copper provides a reliable connection with maximum conductivity. By using 100% virgin copper the tin won’t flake off, something commonly seen when using recycled copper materials. While it is also common to tin just the tips of the wire for cost savings, this practice does not actually provide any benefits. Metra’s amp kits use fully tinned copper wire from top to bottom that can withstand a harsh marine environment and salty air. The ignition-protected 50-amp circuit breaker is IP67 rated with stainless steel connection points for corrosion resistance
Amplifier Wiring Kit:
- Marine compliant amplifier wiring kit
- Fully tinned 100% virgin copper wire
- BC5W2 marine compliant jacket
- 50-amp marine circuit breaker is rated IP67 with stainless steel connection points for corrosion resistance
- Easy to solder tinned wiring
- Connectors, ring terminals, and wire ties included
What’s in the box:
- (1) 8-gauge tinned oxygen-free copper side-by-side red power and yellow ground wire (10ft.)
- (1) 18-gauge tinned oxygen-free copper blue remote turn-on wire (18ft.)
- (2) 8-gauge ring terminal with shrink tube and logo, pre-terminated on each end of the 2ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on 8ft. red wire
- (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on yellow wire
- (1) Ignition protected circuit breaker (50-amp)
UPC Code 086429416820
