2x Kicker CSC65 CS Series 6.5" 300 Watt Max Power 4 Ohm 2-Way Coaxial Speakers, 2x75 Watts 2-Channel Class AB Amplifier w/Kit + Booster Kit with Quick Disconnect Power Block, DSP Harness, Speaker Wire

---

Use to add an amp or use with AXDSPX-WR. Add an amp harness 1998-2013 HD with OE radio and fairing. Pre-wire for the AXDSPX-WR, input and output harnesses included. Provides pre-terminated input and output wires. RCA output harnesses included. Pre-wired rear speaker plug, used with BC-9720 backbone harness. Universal for all amps on the market. Wire covered in protective cloth tape.

DSP Amp Harness:

• Use to add an amp or use with AXDSPX-WR
• Add an amp harness 1998-2013 HD with OE radio and fairing
• Pre-wire for the AXDSPX-WR, input and output harnesses included
• Provides pre-terminated input and output wires
• RCA output harnesses included
• Pre-wired rear speaker plug, used with BC-9720 backbone harness
• Universal for all amps on the market
• Wire covered in protective cloth tape

UPC Code 086429407880

---

Big sound meets big value. Use this flexible two-channel KM-Series Marine amplifier to power your system like only KICKER can! Using Class A/B power, this amp features a variable bass boost with KickEQ giving you as much as 6dB of extra bump. A powerful 12dB crossover is also included, letting you quickly tune your system to perfection.

General Features:

• Class A/B
• 190 Watts of Dynamic Power
• Stereo Amplifier with Bridging Capability
• Conformal-Coated Circuit Board
• Variable 12dB Crossover
• KickEQ Variable 6dB Bass Boost
• Real Marine ABYC/NMMA-Compliant Power Connections
• 316L Stainless-Steel Hardware Included
• POWER [watts/ch], 2 OHM STEREOL: 75 x 2
• POWER [watts/ch], 4 OHM STEREO: 40 x 2
• POWER [watts/ch], 4 OHM BRIDGED MONO: 150 x 1
• FREQUENCY RESPONSE [Hz]: 10-20k, +0/-1dB
• INPUT SENSITIVITY: High Level 250mV-10V, Low Level 125mV-5V
• SIGNAL-TO-NOISE RATIO: >95dB, a-weighted, re: rated power
• ACTIVE CROSSOVER: 12dB/octave, variable 50-200Hz, selectable high pass, low pass or all pass
• KickEQ BOOST: Variable 0-6dB, centered @ 40Hz

UPC Code 713034020363

---

These CS-Series 6-1/2-inch Coaxial Speakers are the perfect way to upgrade your factory speakers. CS-Series Coaxials deliver remarkable performance and ultra-clean bass with a heavy-duty motor/magnet structure not found in stock speakers. The stamped-steel framework supports a rigid polypropylene cone with EVC (Extended Voice Coil) technology for the best sonic quality. Using zero-protrusion PEI tweeters with neodymium magnets, you get the clarity you need without interfering with factory grilles. These CS speakers work best with 100 watts of recommended power.

General Features:

• 6.5" 2-Way Design Speaker
• 300W Peak Power
• 100W RMS Continuous Power
• 90dB Sensitivity
• 40-20kHz Effective Frequency Range
• Zero-protrusion tweeters to fit nearly any factory depth
• UV-treated poly-foam surround resists heat or direct sunlight
• Large woofer magnet in a heavy-duty motor for ultra-clean bass
• PEI-tweeter construction provides superb clarity
• Neodymium tweeter magnets allow for increased volume in high frequencies
• Steel mesh grilles included for speaker protection

UPC Code 713034088363

---

Power your marine amplifier with a wiring kit that can withstand the harsh environment and still deliver full sound performance. Fully tinned wiring ensures that these amp kits won’t corrode or oxidize and turn green after a season on the water. Oxygen-free copper provides a reliable connection with maximum conductivity. By using 100% virgin copper the tin won’t flake off, something commonly seen when using recycled copper materials. While it is also common to tin just the tips of the wire for cost savings, this practice does not actually provide any benefits. Metra’s amp kits use fully tinned copper wire from top to bottom that can withstand a harsh marine environment and salty air. The ignition-protected 50-amp circuit breaker is IP67 rated with stainless steel connection points for corrosion resistance

Amplifier Wiring Kit:

• Marine compliant amplifier wiring kit
• Fully tinned 100% virgin copper wire
• BC5W2 marine compliant jacket
• 50-amp marine circuit breaker is rated IP67 with stainless steel connection points for corrosion resistance
• Easy to solder tinned wiring
• Connectors, ring terminals, and wire ties included

What’s in the box:

• (1) 8-gauge tinned oxygen-free copper side-by-side red power and yellow ground wire (10ft.)
• (1) 18-gauge tinned oxygen-free copper blue remote turn-on wire (18ft.)
• (2) 8-gauge ring terminal with shrink tube and logo, pre-terminated on each end of the 2ft. red wire
• (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on 8ft. red wire
• (1) 8-gauge ring terminal with shrink tube and logo, pre-terminated on yellow wire
• (1) Ignition protected circuit breaker (50-amp)

UPC Code 086429416820

---

Enrocks EORA102 is a universal AM/FM antenna that is easy to hide in your motorcycle, automobile, truck, and even boat! Just hide it anywhere. Simply hook up, peel, and stick. Will stick on to glass, roof, headliner, inside the camper, mounts to any surface.

General Features: 

• Electronic Stereo Radio Hidden Amplified Antenna Kit
• Hidden Amplified Antenna Design for Direct Replacement
• Covering all AM / FM Broadcast Radio
• Input: Thoroughfare / Output Impedance: 750HM
• Dimension: 3.75" X 1" X 0.75"

Installation Instructions

• Connect Antenna Plug of this unit to Car Radio Antenna Socket
• Connect Black 12v positive to accessories
• Secure Antenna to clean flat surface
• Connect Silver wire to good ground
• If extra gain/pickup is required, connect the red wire to positive side of rear window demister. (this connection is optional)​​

UPC Code 728120484479

---

This durable, quick disconnect allows for convenient, safe installation and servicing of amps, active subwoofers, or removable winches in powersport and marine applications. This product is designed for use in the harshest environments, unlike standard audio equipment that is not suited for off-road applications. This important part of your installation can resist the elements to keep the system working great throughout all of your rugged outdoor adventures.

Power Block:

• 2.5” W x 2” L x 2.25” D
• Accepts 4 AWG power and ground
• Remote turn-on lead
• Machined brass block
• Has rubber boot to protect from the elements

UPC Code 086429430413

---

A ground-breaking virgin-PVC, Hyper-Flex insulation and multi-strand construction allows you to bend, twist, and contort the cable in any way imaginable for an ultimate installation experience while delivering maximum current flow; remains ultra-flexible under hot or cold temperature extremes; transfers the cleanest audio signal possible by using tightly twisted, silver-tinned OFC copper conductors; zip line to easily remove outer insulation.

Speaker Wire:

• 20 Feet
• 16 Gauge
• Silver-tinned OFC (oxygen-free copper)

UPC Code 632016086404