JBL Marine Gauge BT Receiver, 2x 8" 450W LED Speakers, Amp w/Kit, Antenna, Wire
JBL Marine Gauge Hole Mount Bluetooth AM/FM Radio Receiver
JBL JAM3000 marine gauge style audio receiver is designed for multi-element environments engineered to meet the demands in extreme environments featuring bluetooth connectivity, AM/FM radio tuner, built in amplifier, USB port for audio playback, 2.8-inch display screen and is IP66 waterproof rated.
General Features:
- 2.8” Monochrome LCD Display
- 15 Watts x 4 Channel @ 4ohm
- Supports multiple audio sources
- Bluetooth, USB, AM/FM
- Audio output - RCA & Speaker level
- IP66 Marine Rated
- RMS Power Output 15Wx4
- 3Ch/2V Pre-out
- Eco-friendly Packaging
- Mounting options: Front & Rear
What's In The Box:
- 1 x radio
- 1 x accessory harness
- 1 x mounting bracket
- 1 x foam gasket for sealing at rear mounting surface
- 2 x foam strip gasket for sealing at front mounting surface
- 4 x mounting screws
- 2 x mounting bolts for top mount
- 4 x flanged nuts
- 2 x lock washers
- 1 x owner’s manual
- 1 x safety sheet
UPC Code 050036399432
JBL Club 82 8" 450W Peak Power 2-Way Marine Speakers with RGB Lighting, White & Gray Grilles (Pair)
JBL Club Marine Speakers are ready for your next outdoor adventure. These fully marinized speakers not only deliver JBL sound, they also provide RGB lighting to bring the sound to life. Engineered to withstand sun, salt, sea spray and wash downs, they feature sealed motor structures, UV resistant one-piece cast-polymer baskets, a sealed magnet and rubber surrounds.
The polypropyelene cone and balanced silk dome tweeter provide great bass, smooth highs and lots of output to ensure every note can be heard loud and clear. With two grille colors included in the box, you can easily match your speaker grilles with your boat.
Club Marine 8" Two-Way Speaker
- Power Handling: 150Wrms, 450W peak
- Sensitivity (@ 2.83V): 92dB
- Frequency Response: 30Hz – 20kHz
- Nominal Impedance: 4ohm
- 2x Full-Range Speakers
- 2x Speaker Grilles, Gloss White
- 2x Speaker Grilles, Satin Grey
- Stainless steel mounting hardware
- Drill bit for easy installation
- Foam gasket
- 2x Speaker Pigtail Harness
- 2x RGB Pigtail Harness
- 2x JBL sticker
- Quick Start Guide
UPC Code 050036390446
JBL Marine A1504 150 Watts RMS x 4 @ 4 Ohms 4-Channel Full Range Boat Amplifier
The Marine A1504 4-channel amplifier delivers a powerful 150-Watts RMS to each of the front and rear speakers in your boat. You can also bridge the amp to 2-channel mode to drive a couple subs with 450 watts RMS or 3-channel mode to drive both a pair of full range speakers and a subwoofer. Speaker-level inputs allow this amplifier to integrate into almost any system, even one using your Marine’s factory radio. Separate high-pass and low-pass crossovers on the front and rear channels allow you dial in the perfect roll off to best suit speaker placement and cabin acoustics.
General Features:
- 4 channel Marine amplifier
- 150 watts RMS x 4 at 4 ohms (225 watts RMS x 4 at 2 ohms)
- 450 watts RMS x 2 at 4 ohms in bridged mode (4-ohm stable in bridged mode)
- Variable high- and low-pass filters (32-320 Hz, 12 dB/octave) on front and rear channels
- Preamp and speaker-level inputs
- Preamp outputs
- Fuse rating: 30A x 3
- 4-gauge power and ground leads recommended — wiring and hardware not included with amplifier
- WxHxD=360mm x 51.3mm x 180mm WxHxD=14-3/16” x 2-1/16” x7-1/8”
UPC Code 050667380595
Enrock 20W White Flexible Rubber Mast Long Range Marine Boat Yacht AM/FM Radio Antenna
The antenna includes a flexible mast for durability, along with a 180 swivel base for increased mounting options. It is corrosion resistant and includes 45 inch cable. Flexible mast. Angled mounting options allow you to install the 20W antenna in the most convenient locations. Corrosion resistant for the marine environment.
General Features:
- Flexible Mast AM/FM Marine Antenna
- 180 degrees Swivel base for maximum mobility and 45 inch cable
- Angled mounting options allow installation of the antenna in the most convenient locations
UPC Code 799861390336
Enrock 8 Gauge Amplifier Wiring Installation Kit
The Enrock 8-Gauge Amplifier Installation Kit makes installing your brand new sound system in your car or truck much easier. It includes all of the cables, wires, tubing, ties, grommets and ring terminals that you will need in order to get your new sound system up and running. The car amp install kit works with a wide range of sound systems and car types and it makes the installation process easy.
General Features:
- 20 ft. 8 GA Red Power Cable.
- Competition High Quality Fuse Holder.
- 1/4" Ring Terminal.
- 3 ft. 8 GA Black Ground Cable #10 Ring Terminal.
- 16 ft. 18 GA Blue Turn-On Wire.
- 20 ft. High Performance RCA (TRCA) Interconnect (3) Rubber Grommets.
- 30 ft. Speaker Wire 5/16" Ring Terminal.
- 6 ft. Split Loom Tubing (20) 4" Wire Ties.
UPC Code 728120451105
Enrock 50 Feet 16 Gauge Marine Grade (OFC) Speaker Wire
Enrock's 16-Gauge Speaker Wire is a smart solution to your audio installation. This wire comes in 50 feet to give you convenient installation and pure sound quality enhancement. The cable is tinned and oxygen free copper (OFC) to deliver high-quality sound without any transmission loss. Marine grade speaker wiring made simple. Just use high quality marine duplex wiring with it's fine stranded tin plated copper to resist corrosion.
General Features:
- Connects audio speakers to your Audio Video (A/V) receiver or amplifier.
- Marine grade tinned wire
- Oxygen Free Copper (OFC)
- Length: 50 Feet
- Gauge: 16
UPC Code 728120479901
1 Year Manufacturer Warranty
